A refrigerator that stops cooling in Glendale most often has a failed fan, a defrost problem, dirty coils or a bad control or sensor; the sealed system is the less common but costlier cause. A technician serving Arapahoe County, or a company around Englewood, Cherry Hills Village and Sheridan, tests the likely parts in order. Call the number on this page to be connected with a local appliance repair company in Glendale.

Short cycling and long runs
A healthy compressor runs in cycles and then rests. One that starts and stops every few minutes, or runs for hours without a break, may have a sensor, start relay, coil or temperature-control problem. Hot afternoons across Arapahoe County make it worse, so note the time of day.
Frost and the defrost system
Frost-free models melt ice on a schedule using a heater, a sensor and a timer or control board. When one piece fails in a Arapahoe County kitchen, ice builds on the evaporator coil, airflow stops and the fresh-food side warms. Forcing a defrost may restore cooling briefly and hide the cause.
Warranty and plan coverage
Before paying out of pocket, check whether the fridge is under the manufacturer's warranty, a home warranty or an extended plan. Warranty repairs usually go through the manufacturer's own service network, so the company you reach can tell you whether your case belongs there or with an independent shop.
After the repair
Ask the technician what was changed and what to watch for in the next few days around Englewood, Cherry Hills Village and Sheridan. A fridge needs hours to pull back down to temperature after a fix, so give it time before judging, as companies around Englewood, Cherry Hills Village and Sheridan advise. Keep the paperwork, since any warranty on the repair depends on it.
Clean the coils safely
Dusty condenser coils make a fridge work harder. Unplug the unit first, then vacuum the grille or back with a brush attachment, as the manual describes. Stop there; panels, wiring, fan covers and the sealed system belong to a technician around Englewood, Cherry Hills Village and Sheridan. Then plug it back in.
Before you call in Glendale
At above 5,000 feet, a gas appliance set up for sea level may not burn as cleanly. Ask whether the tech checks the manufacturer's high-altitude adjustment when a burner or dryer misbehaves.
According to Denver Water, hardness is about 105 mg/L on average, which Denver Water describes as soft to moderately hard. Dishwasher hardness settings and refrigerator filters work best when they match the water.
Gas ranges, ovens, cooktops and dryers in Glendale are served by Xcel Energy. If you smell gas, get everyone out, call 911 from outside, then call Xcel Energy at 1-800-895-2999.
A photo of the rating plate (model and serial number) saves time on the phone and on the first visit.
Nearby, the same kind of help is available in Englewood, Cherry Hills Village and Sheridan.
Refrigerator Repair questions in Glendale
Why is water leaking under my fridge around Englewood, Cherry Hills Village and Sheridan?
What should I do with food while the fridge is down?
Does calling commit me to hiring anyone?
Why does my fridge run all the time?
More appliance repair services in Glendale
Refrigerator Repair nearby
Helpful guides
Sources
Last updated: