A top-load washer that will not agitate or spin and a dryer that runs without heat are two of the most common laundry calls. Each has a handful of possible causes, and the technician narrows them down on site. Call the number on this page to be connected with a local appliance repair company in Edgewater.

Dryer: what you notice
A drum that spins without heat, clothes that stay damp after a long cycle, a loud squeal or thump, a dryer that quits mid-load or a burning smell are the usual reasons for a call. Lint buildup makes nearly all of these worse, so mention how often the vent is cleaned.
Water in the fridge
Puddles inside or beneath a refrigerator often come from a clogged defrost drain, a cracked fill line or a filter that has loosened. Ice makers fail when the inlet valve clogs or the fill tube freezes. Colorado's hard-water areas add scale to that list. Note where the water appears.
With much of Edgewater built in the 1950s, older plumbing and vents can cause slow drains and long dry times that look like an appliance fault. Mention the home's age on the call.
Local details for Edgewater
Edgewater sits above 5,000 feet. Gas burners lose input with altitude; the fuel gas code's rule of thumb derates appliances about 4 percent for every 1,000 feet above 2,000, so mention the elevation if a flame burns yellow or a dryer heats slowly.
Denver Water reports water hardness of about 105 mg/L on average, which Denver Water describes as soft to moderately hard. That mineral content is what leaves scale in dishwashers, ice makers and washer valves over time.
Gas ranges, ovens, cooktops and dryers in Edgewater are served by Xcel Energy. If you smell gas, get everyone out, call 911 from outside, then call Xcel Energy at 1-800-895-2999.
Note any error code on the display and when the problem started. It helps the company you're connected with bring the right parts.
Calls from Edgewater are often matched with companies that also cover Wheat Ridge, Lakewood and Glendale.
Model number matters
Parts are matched by model number, not by appearance, so give the company the full number from the label. It is usually inside the door frame, on the side wall or behind the kick plate. A correct number shortens the visit and lowers the chance of a wrong part.
What the technician does first
- Asks what the appliance did and when
- Checks the model label and age
- Runs a cycle or watches the cooling
- Tests the likely parts
- Explains the cause and options
Approval for the repair comes after the explanation. Plan on a few minutes of questions before any tools come out.
Carbon monoxide alarm
If an alarm sounds, get into fresh air and call 911. Do not go back inside to find the cause. Any gas appliance in the home should be inspected by a professional before it is used again, whether or not the alarm clears. Fresh air comes first.
Whirlpool Appliance Repair questions in Edgewater
Why does my front-load washer smell?
Why does my dryer run but not heat?
Why does my oven not reach temperature?
Does the manufacturer handle warranty repairs?
More appliance repair services in Edgewater
Whirlpool Appliance Repair nearby
Helpful guides
Sources
Last updated: