Double wall ovens share a control but not every part, so one cavity can fail while the other works. Say which side acts up. Call the number on this page to be connected with a local appliance repair company in Aurora.

The upper oven runs, the lower does not
Double wall ovens share a control but not every part. A dead lower cavity with a healthy upper one suggests an element, sensor or relay specific to that side. Homeowners around Watkins often assume the whole unit is finished, when the repair is limited to one chamber.
When the element is not the problem
A wall oven that fails to heat is often blamed on the element, but a bad sensor, a failed relay or an error from the board can leave a perfectly good element cold. Good technicians measure before they replace. That is why a diagnostic visit usually comes before parts are ordered.
Install costs versus repair costs
If a repair is large and the oven is older, a replacement may need cabinet changes, because new models rarely match old cutouts exactly. That adds carpentry and electrical work. Weigh the full total, including installation, against repair before deciding. The technician can say whether your cutout is a standard size.
Know this about Aurora homes
Elevation matters here: Aurora is above 5,000 feet, where water boils at a lower temperature and gas appliances are rated for less input than at sea level.
Aurora Water reports water hardness of about 136 mg/L on average (range 87-198). That mineral content is what leaves scale in dishwashers, ice makers and washer valves over time.
Gas ranges, ovens, cooktops and dryers in Aurora are served by Xcel Energy. If you smell gas, get everyone out, call 911 from outside, then call Xcel Energy at 1-800-895-2999.
Note any error code on the display and when the problem started. It helps the company you're connected with bring the right parts.
Calls from Aurora are often matched with companies that also cover Watkins, Centennial and Greenwood Village.
When replacement is smarter
A cracked cavity, repeated failures in different systems, a discontinued board or damaged door glass may tip the decision toward a new unit. If you do replace, measure the cutout first, since sizes and electrical needs vary between models. Your technician can often confirm what the existing wiring can support.
Quick checks before you call
- Look for a tripped breaker on the oven circuit
- Confirm the control lock or sabbath mode is off
- Check that the clock is set
- Make sure nothing is wedged in the door
Leave the unit's panels and wiring alone. These are the checks most owners can do in under a few minutes, with no tools and no panel removal.
Aurora at a glance
Calls come in from across Aurora, including around Interstate 225, E-470, Interstate 70.
Wall Oven Repair questions in Aurora
Does a wall oven have to come out of the cabinet for repair?
Why is the cabinet around my wall oven warm?
Is a wall oven hardwired?
What if I smell gas near a gas wall oven?
More appliance repair services in Aurora
Wall Oven Repair nearby
Helpful guides
Sources
Last updated: